Switching the low beam off
You are not logged in. Access is limited. Login or see membership information. • Vectrix Owners
Home » Applications » Member Forum » Vectrix Tips and Tricks » Post

This is the place for members to communicate and share ideas as well as a place for potential Vectrix owners to get information from Vectrix owners.


Author Message

ThomasAustria
Full Access

Subject: Switching the low beam off
Vectrix Tips and Tricks
posted by ThomasAustria on Wednesday, May 26th 2010 @ 4:58 AM

Power on the vectrix hold the flash light beam push button till the vectrix will beep 2 times - so the parking light will remain. So if it alowed in your country you can switch it off.

If you press the light button again the light will switch on again. Of course when you are powering on the vectrix again with the key the light will go on again also.


Des Gilmore
Full Access

Subject: RE: Switching the low beam off
Vectrix Tips and Tricks
posted by DesGilmore on Wednesday, September 1st 2010 @ 8:15 PM

Good Tip,

But I've discovered that with mine I need to hold the Flasher switch for at least 8 seconds after turning the ignition on until the headlight switches off.

Thanks.